Fig. 1-5: Signals Terminals - Emerson ROSEMOUNT Xstream X2 Series Instruction Manual

X-STREAM X2FD
Signal inputs and outputs
All signal cables are connected to internal
screw-type terminals (fi g. 1-5), except the optional RJ45 ethernet connector.
Cable cross-section:
Cable entry via
Permissible cable outer diameter:
Available signals:
Detailed terminals confi guration
Installation"

Fig. 1-5: Signals terminals

1-12
1.7 Technical Data
max. 1.5 mm
end sleeves not required.
three IP 68 cable glands or conduits
see cable gland / conduit specifi cation
standard: Analog signal outputs
Relay status signals
Modbus interface (RS232; RS 485)
optional: Digital inputs/outputs
Modbus RJ45 ethernet connector
„Chapter 2
Note!
Depending on the actual analyzer confi guration
not all shown terminals may be provided!
Instruction Manual
HASXMDE-IM-EX
(14 AWG),
2
Emerson Process Management GmbH & Co. OHG
01/2015