ATEX Instruction Manual
ETC01035
02/2008
2.7.4
Power Connection Category 3 Analyzer
We recommend to supply Analyzer and pres-
surization control unit with separate power
cables.
This enables to supply the control unit inde-
pendentlys if in special application pre-pur-
ging the analyzer is required.
Installation instructions for mains termi-
nals:
Strip the cable 8 - 9 mm, press the pushbutton,
insert the cable and release the pushbutton.
Fig. 2-6: Mains Terminals Inside Analyzer
Emerson Process Management GmbH & Co. OHG
2.7.4 Power Connection Category 3 Analyzer
MLT 2 / BINOS
Verify that the mains voltage at
the point of installation meets
the analyzer´s nominal voltage!
EMV mains filter
Mains terminals
100 F
2-19