Table of Contents
Advertisement
PRESYS
Instruments
2.3.4 - Voltage inputs
0 to 55mVdc or 0 to 5 Vdc must be applied to terminals 2 (+) and 3 (-). 0 to 10Vdc
must be applied to terminals 4(+) and 6(-). The connections are shown in figure 7.
2.4 - Output Connections
The Indicator can have up to five output modules: output 1 to 4 are only used as
alarm outputs and the output other one as retransmitter output (4-20 mA, 1-5 Vdc or
0-10 Vdc). Figure 8 shows the Indicator output types.
Note that the output terminals will present the corresponding signals only if
the optional modules are installed and the output is correctly configured. Refer to
section 3.2 on Configuration and 4.3 Optional Modules Installation for further
details.
Installation
Page 10
Fig. 7 - Voltage source connection
DMY-2030-Light-5S-Energy
Advertisement
Table of Contents
