Presys DMY-2030 Light Technical Manual page 36

PRESYS
 Instruments
DISPLAY
Retansmitter Output (Option Module code: MSAN-20X)
To make use of retransmitter output (4-20 mA, 1-5 V or 0-10 V) connect the
optional analog output module in CN1 and CN2 connectors available on the CPU board.
The optional analog output module has two installation jumpers: J1 and J2, as
shown in Figure 25.
Fig. 25 - Location of the jumpers on the analog output board
To configure the analog output optional module for retransmission output 4-20 mA,
1-5 V or 0-10 V just install the jumper as specified in the table below:
Retransmission
Outputs Types
4-20 mA*
1-5 V
0-10 V
(*) In case of retransmitting output 4-20 mA current, you should save the provided
jumper off the instrument or put it on only in one connector pin to not jumper the
connectors.
Maintenance
Page 32
Fig. 24 - Optional Modules Installation
J1
DMY-2030-Light-5S-Energy
COMPONENTS
Jumpers
J2
OPTIONAL MODULE