Table of Contents
Advertisement
PRESYS
Instruments
4.3 - Optional Modules Installation
The DMY-2030-Light-5S-Energy indicator can have up to four alarm outputs and
one analog output. This requires that the corresponding optional modules are installed
inside the unit. Open the indicator as shown in section 4.1 in order to access the four
connectors on the Power Supply Board, plus a connector on the CPU board (see
Figure 23).
The connectors on the Power Supply board are called MOD 1, MOD 2, MOD 3
and MOD4 and correspond respectively to outputs 1 to 4 at the indicator terminals shown
in Figure 3. The connectors of the analog output are located on the CPU board and have
no denomination. Any optional module must always be installed with their components
directed towards the display board, as illustrated in Figure 24.
Fig. 23 - Optional modules Plug in
DMY-2030-Light-5S-Energy
Maintenance
Page 31
Advertisement
Table of Contents
