Recording Mode Setting - JVC GR-DVM70U Instructions Manual

Operation Switch
A M
MENU/SET Dial
Display
FOCUS AUTO
EXPOSURE AUTO
W. BALANCE AUTO
FADER OFF
/ WIPE
P. AE OFF
/ EFFECT
FLASH ADJ. 0
TO MODE MENU
4
END
4 REC MODE SP
WIDE MODE OFF
ZOOM 40X
DIS OFF
GAIN UP AGC
SELF-TIMER OFF
FLASH AUTO
TO DATE / TIME MENU
TO SYSTEM MENU
– – – – – – – – – –
END 6
REC MODE SP
4
WIDE MODE OFF
ZOOM 40X
DIS OFF
GAIN UP AGC
SELF-TIMER OFF
FLASH AUTO
TO DATE / TIME MENU
TO SYSTEM MENU
– – – – – – – – – –
END
6
SP
– – – – – – – – – –
6
Lock Button
Power lamp
Power Switch
Recording Menu
Mode Menu
SP LP
Recording mode
indicator

Recording Mode Setting

Set the tape recording mode according to your preference.
1
SELECT OPERATION MODE
Set the Operation Switch to "
Switch to "
Lock Button. Open the LCD monitor fully or pull out
the viewfinder fully.
•The power lamp comes on and the camcorder is
turned on.
2
ACCESS RECORDING MENU
Press MENU/SET. The Recording Menu appears.
3
ACCESS MODE MENU
Move the highlight bar to "TO MODE MENU" by
rotating MENU/SET. Press it and the Mode Menu
appears.
4
SET RECORDING MODE
First move the highlight bar to "REC MODE" by
rotating MENU/SET. Press it and the parameter "SP"
or "LP" is highlighted. Select "SP" or "LP" by rotating
MENU/SET. Press it twice to exit from the Recording
Menu.
•Audio Dubbing is impossible on a tape recorded in
the LP mode.
•"LP" (Long Play) is more economical, providing
1.5 times the recording time.
NOTES:
If the recording mode is switched during recording, the
playback picture will be blurred at the switching point.
It is recommended that tapes recorded in the LP mode
on this camcorder be played back on this camcorder.
During playback of a tape recorded on another
camcorder, blocks of noise may appear or there may be
momentary pauses in the sound.
". Then, set the Power
" or "5S" while pressing down the
15
EN