Playback Sound - JVC GR-DVM70U Instructions Manual

Playback Sound

During playback, the camcorder detects the sound mode in which the recording was made, and plays the
sound back. Select the type of sound to accompany your playback picture. (32 kHz is preset to "SOUND 1"
and 48 kHz is preset to "FULL SOUND".)
Recording sound
32 kHz
48 kHz
When watching a tape recorded at 32 kHz, if you want to change the output sound, access the Playback Menu
and, in step 3 on page 54, select "32 kHz MODE" and set it for "FULL SOUND", "SOUND 1" or "SOUND 2".
When playing back a tape recorded at 48 kHz, set in the same manner.
NOTES:
You can also use the provided RM-V713U remote control's AUDIO MONITOR button to change the output sound
(without having to access the Playback Menu). Make sure you point the remote control at the camcorder's remote
sensor.
During playback, the camcorder detects the sound mode in which the recording was made. This detection cannot
be made during fast-forward or rewind. During playback the sound mode is displayed in the upper left corner.
Display
DEC 25 ' 98
TC 12 : 34 : 24 PM 5 : 30
Frames*
Seconds
Minutes
*30 frames = 1 second
DEC 25 ' 99
TC 12 : 34 : 24 PM 5 : 30
32kHz/SOUND1
DEC 25 ' 99
TC 12 : 34 : 24 PM 5 : 30
Display
FULL SOUND
SOUND 1
SOUND 2
FULL SOUND
SOUND 1
SOUND 2
TIME CODE
(Displaying The Time Code During Playback)
You can display the Time Code on screen during playback. This is especially
useful for editing. This function is preset to "OFF". To turn it on, select "TIME
CODE" at the Playback Menu and change the setting (
ON– The Time Code is displayed on the playback screen.
OFF– The Time Code does not appear.
DISPLAY
(Displaying the Date During Playback)
If the time has been set, the date is automatically recorded separately from
the recorded video signal. You can display or remove the date anytime
during playback. This function is preset to "ON". To turn it off, select
"DISPLAY" at the Playback Menu and change the setting (
ON– The date is displayed on the playback screen.
OFF– The date is not displayed.
INDICATION
You can make the Playback Sound, Time Code and Date indications
disappear. This function overrides the "TIME CODE" and "DISPLAY"
settings in the Playback Menu. The factory-preset is "ON". To turn it off,
select "INDICATION" in the Playback Menu and change the setting
( pg. 54).
OFF– The Playback Sound, Time Code and Date indications do not appear
on the Playback Screen.
ON– The Playback Sound, Time Code and Date indications are displayed
according to how "TIME CODE" and "DISPLAY" are set in the
Playback Menu.
NOTE:
If "INDICATION" is set in the Mode Menu, "INDICATION" in the Playback
Menu will also be set to the same setting (
Output sound
Stereo sound
Stereo sound
"L" sound is output on both channels
"R" sound is output on both channels
pg. 36 – 39).
55
EN
pg. 54).
pg. 54).