Motor Drive Mode - JVC GR-DVM70U Instructions Manual

32
RECORDING
EN
Lock Button
PHOTO (SNAPSHOT) Button
A M
Operation Switch
SNAPSHOT MODE Button
Display
FULL
PHOTO
Advanced Features For Video And D.S.C. (cont.)
Power lamp
Power Switch
Snapshot mode
During snapshot
Snapshot (For Video Recording)
Use your camcorder like a regular camera and take a
snapshot, or several of them in succession.
This feature lets you record still images that look like
photographs onto a tape.
SNAPSHOT MODE SELECTION
1
SELECT OPERATION MODE
Set the Operation Switch to "
the Power Switch to "
the Lock Button. Pull out the viewfinder fully or open
the LCD monitor fully.
2
SELECT SNAPSHOT MODE
Choose the appropriate mode from among the 5
Snapshot modes (
MODE.
Press SNAPSHOT MODE as many times as necessary
until the desired snapshot mode indicator is displayed.
SNAPSHOT RECORDING
1
TAKE SNAPSHOT
Press PHOTO (SNAPSHOT).
If you press during Record-Standby . . .
.... "PHOTO" appears and a still image will be
recorded for approx. 6 seconds, then the
camcorder re-enters the Record-Standby mode.
If you press during Recording . . .
.... "PHOTO" appears and a still image will be
recorded for approx. 5 seconds, then the normal
recording resumes.
•When the " " flash ready indicator is displayed,
the flash fires.

Motor Drive Mode

Keeping SNAPSHOT pressed provides an effect similar to
serial photography. (The interval between the still images:
approx. 1 second.) However, when "REC SELECT" is set to
"TAPE & CARD" in the System Menu (
Motor Drive Mode does not take place.
To Remove The Shutter Sound. . .
.... when you don't want to hear the shutter sound, set
BEEP/TALLY to "OFF" in the System Menu
( pg. 36 – 39). Though the sound is not heard from
the speaker, it is recorded on the tape.
" or " ". Then, set
" while pressing down
pg. 33) by pressing SNAPSHOT
pg. 39), the