Flash Brightness Adjustment - JVC GR-DVM70U Instructions Manual

Operation Switch
A M
MENU/SET Dial
Display
FLASH ADJ. 0
4
TO MODE MENU
END
4 FLASH ADJ.
2
TO MODE MENU
– – – – – – – – – –
END 6
MANUAL
2
Lock Button
Power lamp
Power Switch
Recording Menu

Flash Brightness Adjustment

When a snapshot (
camcorder fires the flash (
brightness automatically. You can also adjust the flash
brightness manually. When you find that the snapshots
you took look too bright or too dark, adjust it manually.
1
SELECT OPERATION MODE
Set the Operation Switch to "
Power Switch to "
pressing down the Lock Button. Pull out the view-
finder fully or open the LCD monitor fully.
2
ACCESS RECORDING MENU
Press MENU/SET. The Recording Menu appears.
3
SELECT FUNCTION
Rotate MENU/SET to move the highlight bar to
"FLASH ADJ.", then press it. The parameter blinks.
4
ADJUST BRIGHTNESS OF FLASH
Rotating MENU/SET upward increases the number of
the brightness adjustment and rotating MENU/SET
downward decreases it.
•The adjustment range is from –3 to +3.
5
ACTIVATE BRIGHTNESS OF FLASH
Press MENU/SET twice. The flash brightness
adjustment is complete and the normal screen
reappears.
NOTES:
When the battery power is low or when "FLASH" is set
to "OFF" in the Mode Menu, the "FLASH ADJ." setting
cannot be changed.
When you change the subject you are shooting or the
shooting location, set it back to ±0 as described in step 4
and take a snapshot to check the flash brightness. After
doing this adjust to your desired brightness.
pg. 24, 32) is taken in the dark the
pg. 34) and adjusts the
". Then, set the
", "5S" or "
35
EN
" while