Date/Time Settings - JVC GR-DVM70U Instructions Manual

Operation Switch
A M
MENU/SET Dial
Display
P. AE OFF
/ EFFECT
FLASH ADJ. 0
TO MODE MENU
4
END
GAIN UP AGC
SELF-TIMER OFF
FLASH AUTO
TO DATE / TIME MENU
4
TO SYSTEM MENU
– – – – – – – – – –
END
6
DATE/TIME
INDICATION ON
ON SCREEN OFF
DISPLAY ON
4 DATE / TIME DEC 25 ' 99
PM 5 : 30
RETURN
NOTE:
Even if you select "DATE/TIME", if the parameter is not highlighted the camcorder's internal clock continues to
operate. Once you move the highlight bar to the first date/time parameter (month), the clock stops. When you
finish setting the minute and press MENU/SET, the date and time begin operation from the date and time you
just set.
Lock Button
Power lamp
Power Switch
Recording Menu
Mode Menu
Date/Time Menu

Date/Time Settings

Date and time will automatically be recorded on tape at
all times. It is your choice to display it or not during
playback ( pg. 55).
1
SELECT OPERATION MODE
Set the Operation Switch to "
Power Switch to "
pressing down the Lock Button. Open the LCD
monitor fully or pull out the viewfinder fully.
•The power lamp comes on and the camcorder is
turned on.
2
ACCESS RECORDING MENU
Press MENU/SET. The Recording Menu appears.
3
ACCESS MODE MENU
Move the highlight bar to "TO MODE MENU" by
rotating MENU/SET. Press it and the Mode Menu
appears.
4
ACCESS DATE/TIME MENU
Move the highlight bar to "TO DATE/TIME MENU"
by rotating MENU/SET. Press it and the Date/Time
Menu appears.
5
INPUT DATE AND TIME
Move the highlight bar to "DATE/TIME" by rotating
MENU/SET. Press it and "month" is highlighted and
begins blinking.
Rotating MENU/SET, input the month. Press it. Repeat
the procedure to input the day, year, hour and minute.
•Press MENU/SET twice when the highlight bar is set
to "RETURN" to exit.
Regarding Built-in Clock's Rechargeable Lithium Battery
To store the date/time in memory, the clock's rechargeable
lithium battery is integrated in the camcorder. While the
camcorder is connected to an AC outlet using the AC Power
Adapter/Charger, or while the battery pack attached to the
camcorder continues to supply power to the camcorder, the
clock's rechargeable lithium battery is always charged.
However, if the camcorder is not used for approx. 3 months,
the clock lithium battery will become discharged and the
date/time stored in memory will be lost. When this occurs,
first connect the camcorder to an AC outlet using the AC
Power Adapter/Charger for over 24 hours to charge the
clock's rechargeable lithium battery. Then perform the date/
time setting before using the camcorder.
It is also possible to use the camcorder without the date/
time setting.
13
EN
". Then, set the
" or "5S" (or " ") while