JVC GR-DVM70U Instructions Manual page 47

Operation Switch
A M
MENU/SET Dial
Display
4
FOCUS MANUAL
EXPOSURE AUTO
W. BALANCE AUTO
FOCUS
FOCUS
Lock Button
Power lamp
Power Switch
Recording Menu
MANUAL FOCUS
NOTE:
You should already have made the necessary viewfinder
adjustments ( pg. 12). If you have not, do so before
continuing.
1
SELECT OPERATION MODE
Set the Operation Switch to "
Power Switch to "
pressing down the Lock Button. Pull out the view-
finder fully or open the LCD monitor fully.
2
ACCESS RECORDING MENU
Press MENU/SET. The Recording Menu appears.
3
ACCESS "FOCUS"
Rotate MENU/SET to move the highlight bar to
"FOCUS", then press it.
4
ACCESS MANUAL FOCUS
Rotate MENU/SET to display "MANUAL", then press
it. The Recording Menu disappears and "FOCUS" is
displayed in the upper left corner. The focus is locked
at this point.
5
ADJUST FOCUS
To farther subject . . .
.... rotate MENU/SET upward. " " appears and
blinks. Go to step 6.
To nearer subject . . .
.... rotate MENU/SET downward. " " appears and
blinks. Go to step 6.
6
END ADJUSTMENT OF FOCUS
Press MENU/SET. Focus adjustment is complete. The
indication changes from "FOCUS" to "MANUAL".
•If you want to reset the focus, repeat from step 2.
To Change To Auto Focus . . .
.... rotate MENU/SET to display "AUTO" then press it in
step 4. The manual focus indicators disappear. Or, set
the Operation Switch to "
NOTES:
After the Power Switch is set to "OFF", Manual Focus is
reset to "AUTO".
Be sure to focus the lens in the maximum telephoto
position when you use the Manual Focus mode. If you
focus in on a certain subject in the wide-angle position,
sharply focused images cannot be obtained when
zoomed up because the depth-of-field is reduced at
longer focal lengths.
When the focus level cannot be adjusted any farther or
closer, " " or " " will blink.
47
EN
". Then, set the
", "5S" or " " while
".