JVC GR-DVM70U Instructions Manual page 31

Operation Switch
A M
START/STOP
Button
MENU/SET Dial
Display
P. AE OFF
/ EFFECT
0
FLASH ADJ.
TO MODE MENU
4
END
GAIN UP AGC
SELF-TIMER ON
4
FLASH AUTO
TO DATE / TIME MENU
TO SYSTEM MENU
– – – – – – – – – –
END
6
MANUAL
– – –
PAUSE
When START/STOP or
PHOTO (SNAPSHOT)
is pressed, the tally
lamp changes as shown:
Lock Button
Power lamp
Power Switch
Recording Menu
Mode Menu
Self-Timer
indication
Self-Timer
Once the camcorder is set, the camcorder operator can
become part of the scene in a more natural way, adding
the final touch to a memorable picture.
1
SELECT OPERATION MODE
Set the Operation Switch to "
Power Switch to "
pressing down the Lock Button. Pull out the
viewfinder fully or open the LCD monitor fully.
•You can tilt the LCD monitor upward to 180
degrees so that it faces forward and view yourself
while self-recording with the viewfinder pushed
back.
2
ACCESS RECORDING MENU
Press MENU/SET. The Recording Menu appears.
3
ACCESS MODE MENU
Move the highlight bar to "TO MODE MENU" by
rotating MENU/SET. Press it. The Mode Menu
appears.
4
SET SELF-TIMER
Move the highlight bar to "SELF-TIMER" by rotating
MENU/SET. Press it and the parameter is highlighted.
Rotate MENU/SET until "ON" appears. Press it twice
to exit from the Recording Menu.
5
ENGAGE SELF-TIMER MODE
Press START/STOP. After 15 seconds, the beep
sounds and video recording starts. To stop Self-Timer
recording, press START/STOP again. The camcorder
re-enters Record-Standby mode.
OR
Press PHOTO (SNAPSHOT). After 15 seconds, the
beep sounds and snapshot recording starts. After that,
the camcorder re-enters Record-Standby mode.
6
END SELF-TIMER RECORDING
Set the Operation Switch to "
Switch to "OFF". "SELF-TIMER" is automatically set
back to "OFF".
¥
Begins blinking Blinks quickly
(Self-Timer starts) (Self-Timer shooting
starts soon)
EN
". Then, set the
" or " " (or "5S") while
" or set the Power
¥
Stops blinking
and stays on
(Self-Timer
shooting starts)
4
After approx. 15 sec.
31