JVC GR-DVM70U Instructions Manual page 25

*:There is the sound of a shutter closing.
To Record An Image With A Title/Frame . . .
PIN-UP .... refer to "Superimposing A Title/Frame" (
Pin-Up mode*
To Remove The Shutter Sound . . .
.... when you don't want to hear the shutter sound, set
NOTES:
FRAME
Snapshot mode
with frame*
FULL
Snapshot mode
with no frame*
MULTI-4
Multi-Analyzer 4
MULTI-9
Multi-Analyzer 9
BEEP/TALLY to "OFF" in the System Menu
( pg. 36 – 39). The sound is no longer hard from the
speaker.
Even if "MULTI-4" or "MULTI-9" is engaged, Snapshot
recording will be performed in the FULL mode during
Digital Zoom. However, the flash will not fire.
If Snapshot recording is not possible, "PHOTO" blinks
when PHOTO (SNAPSHOT) is pressed.
Even if Program AE with special effects (
engaged, certain modes of Program AE with special
effects are disabled during Snapshot recording. In such a
case, the icon blinks.
If shooting is not performed for approx. 5 minutes when
the Power Switch is set to "
from the battery pack, the camcorder shuts off automati-
cally to save power. To perform shooting again, close the
LCD monitor and re-open it. When using the viewfinder,
push back it in and pull it out again.
Motor Drive Mode (
Power Switch is set to "
To reduce the Red-Eye effect of the subject's eyes when
the flash fires, pg. 34.
When a cable or headphone set is connected to the AV
OUT connector, the shutter sound is not heard from the
speaker.
pg. 69).
pg. 44, 45) is
" and power is supplied
pg. 32) is disabled when the
".
25
EN