Adjusting The Door's Accessibility - Hanseatic HGU6082B14U7735ES User Manual

13. Lay the supplied drilling template on the
reverse side of the front panel in such a
way that the drilling template and the front
panel are flush at the top.
14. Transfer the drill holes from the drilling
template to the front panel.
15. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
16. Remove the protective films from the
other Velcro straps and stick the Velcro
straps to the front panel using the drilling
template.
17. Attach the front panel to the appliance
door of the dishwasher using the Velcro
straps (42), hold the panel in place, and
carefully open the appliance door.
Installation, connection and initial commissioning
(45)
18. Remove the 4 screws from the inside of
(42)
Adjusting the door's
accessibility
You can adjust how easy or difficult it is to
open the appliance door. This setting is of-
ten required after the front panel has been
mounted. You can change the spring force of
the door by turning both lower screws.
•
•
(45)
the door. Screw the front panel in place
at these positions using the 4 enclosed
screws (45).
So that the door is easier to access, turn
the screws in an anti-clockwise direction.
To make the door more difficult to access,
turn the screws in a clockwise direction.
Page EN-37