Connecting The Mains Plug; Installing The Appliance Under A Worktop - Hanseatic HGU6082B14U7735ES User Manual

Page EN-32 Installation, connection and initial commissioning
■ Never connect the appliance to the
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
■ Ensure that the inlet hose is not
kinked and is carefully connected.
■ Do not cut through the inlet hose.
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist (see "Service"
on page EN-44).
■ Do not use old or previously installed
inlet hoses.
3
¾ inch
Inlet hose
You will require a valve with a ¾-inch screw
connector for the water supply.
1. Screw the safety valve's lock nut to the
tap (31) hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the tap again.

Connecting the mains plug

WARNING
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
■ Prior to connecting the appliance, en-
sure that you have page EN-4 taken
note of all the safety instructions and
adhered to them.
Fire hazard!
Improper handling of the appliance
can lead to fi re.
■ Never use multi-socket adapters, mul-
ti-socket strips, travel adapters or the
like.
• Please ensure you only connect the de-
vice to a professionally installed protec-
tive contact socket with sufficient fuse
protection (220–240 V~/50 Hz/10 A).
• Ensure that the plug is installed in such a
way that the recess into which the dish-
washer will be fitted is deep enough even
when the plug is plugged in.
• Do not use a multi-socket extension ca-
ble, multi-socket plug, travel adapter, ex-
tension cable or similar.
We recommend using a pulse-sensitive
residual current device (RCD).
• Insert the mains plug into the socket.
If you are setting up your dishwasher as a
freestanding appliance, continue with (see
"Wasserhärtegrad" on page EN-38).
Installing the appliance under
a worktop
NOTICE
Risk of damage to property!
Selecting the wrong screws can dam-
age the worktop.
■ Ensure you select the correct screws
with the appropriate screw length.
■ Use the enclosed screws.
• Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
• Maintain sufficient distance from the walls
and adjacent appliances. The recess di-
mensions must at least correspond to the
details in the diagram above, 'recess di-
mensions'.