Changing The Rinse Aid Dose - Hanseatic HGU6082B14U7735ES User Manual

Page EN-14 Dishwasher detergents, rinse aids and dishwasher salts
1. Open the cover (26) of the rinse aid dis-
penser.
2. Fill the water tank to the "max" mark in
the opening.
3. Wipe away any rinse aid which has spilt
immediately so that you don't compro-
mise the rinsing results and to avoid in-
creased foaming.
4. Close the rinse aid dispenser cover (26)
again.

Changing the rinse aid dose

We would recommend that you do not change
the dosage that was set by the factory initially.
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the appliance with the
ton (18).
(5)
(13) (12)
2. Press the button (13) for 5 seconds
within 60 seconds of switching on.
3. Push the button (12) to switch to setting
mode.
The indicator (5) will flash. The current
value ( to ) will illuminate on the dis-
d1 d5
play (10).
4. Press the button (13) as often as re-
quired until the desired dose is displayed
( = low, = high).
d1 d5
5. Around 5 seconds after you push it for the
last time, the appliance will automatically
revert to the normal display.
The selected dose setting is saved.
but-