Adjusting The Door's Accessibility - Hanseatic WQP8-T7736E User Manual

Page EN-28 Installation, connection and commissioning
12. Lay the enclosed drilling template on the
back of the front panel in such a way
that the drilling template and the front
panel are flush at the top.
13. Transfer the drill holes from the drill tem-
plate to the front panel.
14. Drill the marked hole positions using a
Ø 2 mm drill bit.
15. Remove the protective films from the
other Velcro straps and stick the velcro
straps to the front panel using the drilling
template.
16. Fix the front panel to the dishwasher
door using the Velcro straps (h) hold it
firmly and carefully open the door.
(k)
(h)
17. Remove the 4 screws from the inside of
(h)
the door. Screw the front panel in place
at these positions using the 4 enclosed
screws (k).
You have now fitted the front panel.
Adjusting the door's
accessibility
You can adjust how easy or difficult it is to
open the dishwasher door. This setting is of-
ten required after the front panel has been
mounted. You can change the spring force of
the door by turning both lower screws.
To adjust the door
– so that it is easier to open, turn the screws
in an anti-clockwise direction.
– so that it is more difficult to access, turn the
screws in a clockwise direction.
(k)