Regency City Series Owners & Installation Manual page 88

CITY LINE
installation
11. Place Log 4—identify the pin locator and match with the left side
6. Place Log 1 on the top of the installed rear log guides. Follow the
pin on Log 1. Rest the Log 4 on the indent in Log 2 as shown below.
measurements as shown below.
Log 2 in position
7. Position Log 2 as shown and follow the measurements.
8. Place Log 3 to the right front corner of the burner. Follow the measure-
ments as shown. Make the edge of the log sit on top of the log guide.
12. Place Log 5—identify the pin locator and match with the right side
pin on Log 1. Rest the Log 5 on the indent in Log 3 as shown below.
log guide
9. Place Log 6 and Log 7 on the burner locations shown below.
Log 3 Indent
10. Before placing the next log—spread the optional media evenly
throughout the burner tray as shown.
NOTE: Ensure the installed optional media doesn't completely block the
air flow—ensure more than 50% of the airflow is open (shown with 3/4"
crushed black glass).
Completed Install
Do not completely
block air flow
88 | City Series CB40E-12
2
920-074 02.28.19