Regency City Series Owners & Installation Manual page 78

installation
Outer Safety Glass Panel (Barrier Glass) Installation/Removal
Note: Safety glass panels must be installed to operate fireplace.
4. For 3 sided and corner units only:
With front panel installed, proceed to install the side panel(s).
Identify the left and right side panels before installing. Facing the front of
the unit, the right panel will show an arrow pointing to the front of the unit
5. Lift up the side panel with the supplied glass clamps (see procedure on
previous page). Tilt the side of the glass panel inward and lift up and un-
derneath the upper side panel and hook the 2 outer hooks on to the pins,
there is also a panel angle adjustment bracket for the third hook.
Note: The side frame upper panel is shown as transparent to better
illustrate the install (this area is not visible when installing glass).
Note: If the outer safety glass side panels angle too far inward or outward,
remove the side glass panel and adjust on the panel angle bracket,
see details on previous page.
78 | City Series CB40E-12
as shown in the diagram below.
Note: The side frame upper panel was made transparent to better
Note: After the side panel has been adjusted so it is installed at 90º to the
Direction arrow on
side panel bracket,
should point toward
front of unit
6. Repeat Steps 4 and 5 to install the opposite side panel.
7. Reverse Steps to remove all panels.
Note: When removing panels, we recommend using the supplied glass clamps.
Panel angle
bracket
illustrate the install (this area is not visible when installing glass).
unit and not flaring in or out, check to ensure there is no gap between
the front and side panel. If there is a gap as shown below, slide the
side panel to adjust the position and close the gap.
Barrier Glass Install