Assembly; Mounting Types; H-Rail Mounting - Festo CPX-AP-A Operating Instructions Manual

Assembly

6 Assembly
6.1

Mounting types

The following mounting types are available, depending on the version:
Mounting
CPX-AP-A modules
Tab. 5: Mounting types
Mounting conditions and dynamic load è Instructions, assembly for CPX-VTSA.
6.1.1

H-rail mounting

The mounting points of the automation system are restricted to the end plates. The interlinking
module and end plates are attached to the H-rail.
2
1
Fig. 14: H-rail mounting
1
Clamping piece
1. Make sure the mounting surface supports the weight
2. Mount the H-rail and make sure there is enough free space for connections.
3. Mount H-rail every 100 mm on the mounting surface.
4. Mount the clamping piece on the right and left end plates.
5. Attach the automation system to the upper slot of the H-rail.
6. Swivel the automation system to the H-rail.
16
Wall
Mounting bracket
CAFM-X5-A
Mounting system
Mounting bracket
CAFM-X5-K
2
H-rail
Festo — CPX-AP-A — 2022-07
H-rail
Mounting
CAFM-X5-H