Saving And Default Value - ICP DAS USA I-7530 Series User Manual

3.5 Saving and default value

After the user selects the parameters in the "setting screen", and click the "Save All
Setting" button to write the parameters into the EEPROM of the CAN converter, but if
the user wants to restore the parameters to the factory default values, please click the
"Load Default Setting" button to restore all the parameters of the "Setting Screen" to the
default values, and then click the "Save All Settings" button to write the parameters into
the EEPROM of the CAN converter. Finally, set the Init/Normal of DIP switch to Normal,
and power on the CAN converter again to start using these parameters.
The default values of CAN converter as below table:
UART side
Baud Rate
Data Bit
Stop Bit
Parity Bit
Add Checksum
Error Response
Timestamp Response
CAN side
CAN specification
CAN baud rate
acceptance code (ACC)
acceptance mask (ACM)
Communacation mode
mode
I-7530, I-7530A, I-7565, I-7530-FT, tM-7530, tM-7530A, tM-7565 User Manual Version 1.6
Copyright © 2018 ICP DAS Co., Ltd. All Rights Reserved E-mail: service@icpdas.com

115200：I-7530、I-7530A、tM-7530、tM-
7530A、tM-7565 and I-7530-FT

921600：I-7565
8
1
None
Disable
Disable
Disable
2.0A
125k
000
000
Normal mode
50
Page: