ICP DAS USA I-7530 Series User Manual page 49

Uart to can bus

Hide thumbs Also See for I-7530 Series:

Table of Contents

 User-defined: This function allows the user to define the ending character,

and only suppout tM-7530, tM-7530A and tM-7565. Among them, "User

Defined1" and "User Defined2" can set 1 end character an d 2 end characters

respectively as beolw figure, when "User Defined2" is selected and the end

characters are set to 0x0D and 0x0A, when the CAN converter receive 0x0D

and 0x0A, and the received data will be added to the end character and then

sent to the other side.

＊ Pair Connection Command Timeout: Set the waiting time when receiving data,

and only suppout tM-7530, tM-7530A and tM-7565. When the CAN converter

receives a byte data, it will wait for this time to confirm whether new data has been

received. If no new data is received after this time will determined that the data is

received completely, and will send the data to the other side.

"CAN Timeout" can set the timeout time for converting CAN data to UART data, and

"UART Timeout" can set the timeout time for converting UART data to CAN data. If the

user wants to send the data immediately, the value can be set to 0.

Among them, the function of "UART Timeout" will only work when "End Characters

of UART Commands" is set to "None". In addition, about the application of the pair

connection mode, please refer to section 5.6.

I-7530, I-7530A, I-7565, I-7530-FT, tM-7530, tM-7530A, tM-7565 User Manual Version 1.6

Page:

Table of Contents

I-7530I-7530a I-7565 I-7530-ft Tm-7530 Tm-7530a ... Show all