ICP DAS USA I-7530 Series User Manual page 25

Uart to can bus

Hide thumbs Also See for I-7530 Series:

Table of Contents

I-7530, I-7530A, I-7565 and I-7530-FT in CAN communication port (DB9 male) pin

assignment is based on CANopen DS102 introduction and the DeviceNet specification.

The wiring method is as follows:

Figure: I-7530 series CAN bus wiring method

The CAN interface of the tM-7530 uses spring-loaded terminals, and the wiring methods

as follows:

Figure: tM-7530 CAN bus wiring method

I-7530, I-7530A, I-7565, I-7530-FT, tM-7530, tM-7530A, tM-7565 User Manual Version 1.6

Page:

Table of Contents

I-7530I-7530a I-7565 I-7530-ft Tm-7530 Tm-7530a ... Show all