ICP DAS USA I-7530 Series User Manual page 48

Uart to can bus

Hide thumbs Also See for I-7530 Series:

Table of Contents

＊ End Characters of UART Commands: The CAN converter will according to the

end character to judge whether the data reception is completed. If the reception is

completed, the CAN converter will add the end character to the received data and

send it to the other side as below figure. For example: if the end character is CR

(0x0D), as long as the CAN converter receives CR, it will be regarded as the

completion of data reception, and the received data will be added to the end

character, and then sent to the other side.

 None: The end character is not used, so the CAN converter will transmit the

received data to the other side until a "Pair Connection Command Timeout"

occurs, or the firmware buffer is full.

 CR: Set the end character as CR, and the hexadecimal value of ASCII code is

"0x0D".

 LF: Set the end character as LF, and the hexadecimal value of ASCII code is

"0x0A".

 CR_LF: Set the end character as CR and LF, and the hexadecimal values of

ASCII code are "0x0D" and "0x0A".

 LF_CR: Set the end character as LF and CR, and the hexadecimal values of

ASCII code are "0x0A" and "0x0D".

I-7530, I-7530A, I-7565, I-7530-FT, tM-7530, tM-7530A, tM-7565 User Manual Version 1.6

Page:

Table of Contents

I-7530I-7530a I-7565 I-7530-ft Tm-7530 Tm-7530a ... Show all