On Timer Operation - Daikin J Series Service Manual

SiBE041101
2.9

ON TIMER Operation

ON TIMER Operation

To use ON TIMER operation
• Check that the clock is correct. If not, set the clock to the
present time.
1. Press
• " " and setting time are displayed on the LCD.
• "
• " " blinks.
2. Press
the point you like.
• Each pressing of either button increases or decreases
the time setting by 10 minutes. Holding down either
button changes the setting rapidly..
3. Press
• The TIMER lamp lights up.
To cancel ON TIMER operation
4. Press
• " " and setting time disappear from the LCD.
• " " and day of the week are displayed on the LCD.
• The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
NOTE
In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
22
Operation Manual
.
" is displayed on the LCD.
until the time setting reaches
again.
.
(Example)
Present time: 23:00
(The unit operating)
OFF TIMER at 0:00
Combined
ON TIMER at 14:00
Operation Manual
64