Region (A.k.a. Regulatory Domain); Finishing The Wireless Setup - Intermec EasyCoder PF2i Installation Instructions Manual

<STX><SI>wt,SPEED<ETX>
Transmits network speed.

Region (a.k.a. Regulatory Domain)

Some countries and regulatory authorities only allow the use of a subset
of the 14 channels specified in the 802.11b/g standard. To make the
product world configurable the setup variable ".REGION" is used.
The region can only be set by personnel authorized by Intermec. If the
wrong region/domain is set, please contact your Intermec representative
immediately. Continued use of the EasyLAN Wireless network interface
with an incorrect REGION setting may be in violation of applicable
laws.
The region setting will not be reset to default, even if a factory default
upgrade is performed.
The following regulatory domains are implemented:
Regulatory Domains
Value
FCC (or USA)
IC (or Canada)
ETSI (or EU)
MKK (or Japan)
/. Certain restrictions apply to outdoor use in France.
1
<STX><SI>wt,.REGION<ETX>
Transmits the active region.

Finishing the Wireless Setup

You can now disconnect the printer from the PC. You still need to assign
an IP address, subnet mask, default router, and name server. This can be
done via the printer's display and keyboard (provided the server supports
DHCP or BOOTP). If not, you must rely on wireless communication
and use the ARP'n'PING method, which require that there is a working
wireless LAN and the printer is inside the coverage area of an access
point.
EasyLAN Wireless Interface Kit Installation Instructions
Countries
U.S.A
Canada
EU countries + Iceland,
1
Liechtenstein, Norway, and
Switzerland
Japan
Chapter  — Setup in IPL
Allowed Channels
1-11 (default)
1-11
1-13
1-14