Intermec EasyCoder PF2i Installation Instructions Manual page 22

Chapter  — Physical Installation
Put back the cover over the electronics compartment.
17
Route the cable from the display unit above the ribbon motor.
18
Connect the cable to connector J50 at the upper front corner of the
CPU board.
Connect the power cord and switch on the power.
19
Enter Setup Mode and print the test label "Hardware Info" in
20
Fingerprint or "HW" in IPL to see if the printer detects the EasyLAN
Wireless interface board. For information on how to enter the Setup
Mode and print test labels, refer to the printer's user's guide.
Cable tie
Antenna
cable
Antenna
EasyCoder PMi Printer
0
Cable clips
EasyLAN Wireless Interface Kit Installation Instructions
Light guide #T20 Torx screw
and spacer
EasyLAN adapter
board