Step-By-Step Instructions; Easycoder Pf2/4I Printers - Intermec EasyCoder PF2i Installation Instructions Manual

Easylan wireless interface kit

Hide thumbs Also See for EasyCoder PF2i:

Table of Contents

Chapter — Physical Installation

Step-by-Step Instructions

Switch off the printer and disconnect the power cord.

Disconnect all communication cables.

Remove the cover over the electronics compartment, as described on

the pages ahead.

The electronic compartment contains wires and

components with dangerous voltage (up to 380V). Make

sure that the printer is switched off and the power cord is

disconnected before the left-hand cover is removed.

Open the right-hand door.

Using a #T20 Torx screwdriver, remove the three screws and lift the

cover up so it disengages the bottom plate.

Swing out the rear part of the cover so you can disconnect the console

cable from the CPU board.

Put the cover aside on a soft cloth or similar to avoid scratches.

EasyLAN Wireless Interface Kit Installation Instructions

Table of Contents

Do you have a question about the EasyCoder PF2i and is the answer not in the manual?