Reading Wireless Connection Setup - Intermec EasyCoder PF2i Installation Instructions Manual

wrong region/domain is set, please contact your Intermec representative
immediately. Continued use of the EasyLAN Wireless network interface
with an incorrect REGION setting may be in violation of applicable
laws.
The region setting will not be reset to default, even if a factory default
upgrade is performed.
The following regulatory domains are implemented:
Regulatory Domains
Value
FCC (or USA)
IC (or Canada)
ETSI (or EU)
MKK (or Japan)
/. Certain restrictions apply to outdoor use in France.
1
SETUP GET "wlan",".REGION",A$
Gets the active region in A$.

Reading Wireless Connection Setup

All settings can be returned to the host via a specified serial
communication port, usually "uart1:", using the Fingerprint instruction
SETUP WRITE "wlan" or SETUP WRITE "8021x".
Example:
SETUP WRITE "wlan","uart1:"
Provided the current user is logged in as admin, this will produce a full
list of wireless setup parameters:
SSID qwerty
WEP1 ****
WEP2 ****
WEP3
WEP4
.WEP_KEY 0
AUTH SHARED
WPA OFF
EasyLAN Wireless Interface Kit Installation Instructions
Countries
U.S.A
Canada
EU countries + Iceland,
1
Liechtenstein, Norway, and
Switzerland
Japan
Chapter  — Setup in Fingerprint
Allowed Channels
1-11 (default)
1-11
1-13
1-14