Changing The Printer's Setup - Intermec EasyCoder 501XP Programmer's Reference Manual

BREAK <device> ON | OFF
<device>
Default:

6.19 Changing the Printer's Setup

The basis for how the printer works is the setup in the Setup Mode.
There are several ways to change the setup:
• Manually using the printer's built-in keyboard, see the User's Guide for
the respective printer model.
• Remotely using Intermec Shell's Terminal Setup, see the User's Guide
for the respective printer model.
• Remotely using setup fi les, see Intermec Fingerprint v7.80, Program-
mer's Reference Manual.
• Remotely using setup strings, see below.
• Remotely via Internet or Intranet using of the printer's home page.
Requires an EasyLAN 100i interface board.
• Remotely using various software packages, such as PrintSet or Label-
Shop.
The various setup parameters are described in the User's Guide for the
respective printer model.
Setup strings allow you to change individual setup parameters directly
from the host:
SETUP "<setup string>"
<setup string>
Intermec Direct Protocol v7.80 Programmer's Reference Manual
corresponds to the same parameter in the BREAK instruction.
Communication channels disabled.
Keyboard enabled.
see list on next page
Chapter 6 — Setting Up the Printer
73