Bar Code Interpretation - Intermec EasyCoder 501XP Programmer's Reference Manual

Specify Bar Codes (combined instruction)
The instruction is primarily intended for complex bar codes (see
BARSET
Chapter 8.1), but can also be used to specify simple one-dimensional bar
codes with a single instruction:
BARSET "<code name>",<ratio wide bars>,<ratio narrow bars>,<magn.>,<height>
<code name>
<ratio wide bars>
<ratio narrow bars>
<magnifi cation>
<height>
All parameters reset to default by PRINTFEED (PF)

Bar Code Interpretation

Most bar codes do not automatically include any bar code interpretation.
If a bar code interpretation is required, it must be enabled and the single-
byte font to be used for the interpretation must be specifi ed.
BARFONT | BF [#<start parameter>,]"<font name>"[,<font height>[,<font slant>[,<vert.
off set>[,<height mag>[,<width mag>[,<width in %>]]]]]][ON]
<start parameter>
<font name>
<font height>
<font slant>
<vert. off set>
<height mag>
<width mag>
<width in %>
<ON>
All parameters reset to default by PRINTFEED (PF)
Bar code interpretation printing can also be enabled or disabled using
these instructions:
BARFONT ON | BF ON
↔ ↔
BARFONT OFF | BF
↔ ↔
By default, bar code interpretation is disabled.
Intermec Direct Protocol v7.80 Programmer's Reference Manual
is the bar code designation
(default "INT2OF5")
specifi es thickness of wide bars
(default 3)
specifi es thickness of narrow bars
(default 1)
specifi es magnifi cation
(default 2)
specifi es height of bars in dots
(default 100)
specifi es where in the syntax the command starts (default 1)
specifi es a single-byte bar code font (default: Swiss 721 BT)
specifi es the size of the font in points (default: 12)
specifi es the slant of the font in degrees (default: 0)
specifi es distance from bar code to interpretation (default: 6)
specifi es vertical font magnifi cation (default: 1)
specifi es horizontal font magnifi cation (default: 1)
specifi es the width in % relative the font height (default: 100)
enables printing of bar code interpretation (default: OFF)
OFF
Chapter 4 — Label Design
35