Enabling/Disabling Automatic Cutting; Enabling/Disabling The Print Key; Producing Audible Signals - Intermec EasyCoder 501XP Programmer's Reference Manual

Chapter 6 — Setting Up the Printer

6.8 Enabling/Disabling Automatic Cutting

Some printers can, as an option, be fi tted with a paper cutter that can cut
non-adhesive continuous stock or the liner between labels.
As an alternative to issuing separate instructions, you can enable or
CUT
disable automatic cutting in connection with each operation.
PRINTFEED
By default, automatic cutting is disabled.
The amount of media to be fed out before automatic cutting and be
pulled back afterwards can optionally be specifi ed:
CUT [<feed length>] ON | OFF
<feed length> is the desired length in dots.

6.9 Enabling/Disabling the Print Key

All printers have a key on its front panel, usually labelled "Print", which
can be used to initiate a operation.
PRINTFEED
You can enable or disable this function by means of the following
instruction. By default, the <Print> key is disabled.
PRINT KEY ON | OFF

6.10 Producing Audible Signals

The printer can emit audible signal from its built-in beeper. There are
two instructions you can use for that purpose, for example to give warn-
ing signals to the operator:
BEEP
Emits a short beeping sound.
SOUND <frequency in Hz>,<duration in units of 0.02 sec's>
Produces a sound of variable frequency and duration.
Intermec Direct Protocol v7.80 Programmer's Reference Manual 65