Using Erplabel Setup - Intermec EasyCoder 301 Installation And Operation Manual

Using ERPLabel
Setup
ERPLabel v. 2.0 for SAP R/3 – Installation & Operation Ed. 1
There is a fine tuning tool included in the ERPLabel. The purpose
is to set some parameters that can improve the performance or as-
sist in Debugging in case an error should occur.
The Setup is accessed through the Tools menu.
General tab
The General tab sets following parameters:
Output File Line Length
Sets the maximum length of the ITF file lines. Default is 75.
SAPscript can not accept more than 80.
Post Process
Remove Input File
Default On. Set it to Off, If you want to keep the initial POF file
even after converting it to a ITF file, for debugging purpose.
Show Input File
Default Off. Set it to On, if you want to bring up the Input File in
your favourite editor during the test phase. You will have to associ-
ate the extension for the POF file with your Editor, to make it work.
Show Output File
Default Off. Set it to On, if you want to bring up the ITF File in your
favourite editor during the test phase. You will have to associate the
ITF extension with your Editor, to make it work.
ERPLabel for SAP R/3
31