Intermec EasyCoder 7421 Quick Reference Manual
Intermec easycoder 7421: reference guide
Hide thumbs
Also See for EasyCoder 7421:
- User manual (100 pages) ,
- Setup manual (14 pages) ,
- Supplementary manual (10 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Intermec EasyCoder 7421
Summary of Contents for Intermec EasyCoder 7421
- Page 1 Quick Reference Guide P/N 066389-001 7421/7422 Battery Pack...
- Page 2 U.S. media supplies ordering information: 1-800-227-9947 Canadian service and technical support: 1-800-688-7043 Canadian media supplies ordering information: 1-800-268-6936 Outside U.S. and Canada: Contact your local Intermec service supplier. The information contained herein is proprietary and is provided solely for the purpose of allowing customers to operate and/or...
- Page 3 7421/7422 battery pack (Intermec part number 065764) Mounting plate Three mounting screws (M3 x 45 mm) 7421/7422 Battery Pack Quick Reference Guide Battery pack Quick reference guide Mounting screws If any parts are missing, please contact your local Intermec representative. Mounting plate 7421B.001...
- Page 4 Power on/off The power on/off switch turns the battery pack on and off. The battery pack must be on for the printer to print or for the battery pack to accept a charge.
- Page 5 Note: After you charge the battery pack for the first time, you can recharge the battery pack while it is attached to a printer you are using. For help, see “Recharging the 7421/7422 Battery Pack While...
- Page 6 2. Disconnect the printer power cable and interface cable. 3. Remove any label stock or ribbon rolls. 4. Remove the four rubber feet from the bottom of the printer. 5. Position the mounting plate with the vents facing the front of the printer.
- Page 7 Installing the 7421/7422 Battery Pack 7421B.003 Mounting plate Battery pack...
- Page 8 9. Slide the front of the printer into the holding bracket on the front of the battery pack. Press the back of the printer down into the latch on the rear of the battery pack. Holding bracket Latch Printer Mounting...
- Page 9 10. Plug the power cable into the power connector on the back of the printer. 7421B.005 11. Reconnect the printer interface cable. 12. Turn on the battery pack and the printer.
- Page 10 7421/7422 Battery Pack 1. Turn on the battery pack and the printer. 2. Use the printer until the battery low LED turns on (after an average of 8 hours of operating time). 3. When the battery low LED comes on, turn off the printer and the battery pack.
Need help?
Do you have a question about the EasyCoder 7421 and is the answer not in the manual?
Questions and answers