Setting Up Printer Drivers; Label Design - Intermec EasyCoder 301 Installation And Operation Manual

Setting Up Printer
Drivers

Label Design

ERPLabel v. 2.0 for SAP R/3 – Installation & Operation Ed. 1
To get a correct output to SAPscript, the printer driver settings must
be set up properly, or you may get an unexpected result.
Detailed descriptions are available in the following chapters:
• Fingerprint – Host Mode Appendix A
• Direct Protocol – Host Mode Appendix B
• Direct Protocol – Stored Mode Appendix C
• IPL– Host Mode Appendix D
• IPL– Stored Mode Appendix E
Alternatively you can call up a pre-defined empty label that con-
tains the correct settings.
Following empty labels are included:
Fingerprint
e_fp.lab
Direct Protocol
e_dp_h.lab
e_dp_s.lab
IPL
e_ipl_h.lab
e_ipl_s.lab
The label design for SAP is done just like any other label design,
but there are a few things to keep in mind, to make it work smoothly.
Fixed text: Can use printer resident or True Type fonts. As
True Type fonts are transmitted as graphical
bitmaps, the printout is slower.
Variable text: Only printer resident fonts can be used.
Lines/Boxes: Supported
Bar codes: Fixed and variable supported. Use printer bar
codes only
Graphics: Use fixed graphics only.
Empty label for Fingerprint Host mode
Empty label for Direct Protocol Host Mode
Empty label for Direct Protocol Stored Mode
Empty label for IPL Host Mode
Empty label for IPL Stored Mode
ERPLabel for SAP R/3
9