IBM IntelliStation A Pro 6217 Service Manual page 108

13. Remove the clip from the side of the drive cage of bays 1 and 2 by sliding the
Figure 17. Drive clips on removable-media drives
14. Push the drive into the bay.
15. Determine whether the drive is an IDE or SCSI device; then, connect one end
16. Route the signal cable so that it does not block the airflow to the rear of the
17. Connect the power cable to the back of the drive. The connectors are keyed
18. If you have other options to install or remove, do so now.
19. Replace the support bracket (see "Removing the support bracket" on page 83).
20. Replace the bezel (see "Removing the bezel" on page 84).
21. Replace the side cover (see "Removing the side cover" on page 81).
92
IBM IntelliStation A Pro Type 6217: Problem Determination and Service Guide
clip to the left; then, snap the clip into the screw holes on the side of the drive
or conversion kit (with the blue side of the clip facing outward) (see Figure 17).
Note: If you are replacing an existing drive, remove the drive clips from the
drive you have removed and install them on the new drive.
Drive clip
of the applicable signal cable into the back of the drive and the other end of
this cable into the applicable IDE or SCSI connector on the system board. See
"Power and signal cables for internal drives" on page 98 for additional
information about cabling drives and "System-board internal connectors" on
page 7 for the location of IDE and SCSI connectors on the system board. If
there are open connectors on the cables connecting existing IDE or SCSI
drives, you can use these cables to connect the new drive.
drives or over the microprocessor.
and can be inserted only one way.