Replacing The Side Cover - IBM IntelliStation A Pro 6217 Service Manual

Replacing the side cover

To replace the side cover, complete the following steps.
Note: The rear adapter-retaining bracket rests against the computer side cover.
You might find it easier to lay the computer on its side to replace the side cover.
1. Make sure that all cables, adapters, and other components are installed and
2. Make sure that the support bracket is installed (see "Removing the support
3. Install the side cover by placing it into position on the computer. Make sure that
Figure 11. Installing the side cover
4. Reconnect the external cables and power cords to the computer; then, connect
5. Turn on the attached devices; then, turn on the computer.
82
IBM IntelliStation A Pro Type 6217: Problem Determination and Service Guide
seated correctly and that you have removed all work tools or parts from inside
the computer.
bracket" on page 83.).
the lip on the bottom of the cover rests on the ledge on the bottom of the
chassis before rotating the cover up to the vertical position. Press down on the
cover-release latch as you slide the side cover forward (see Figure 11) to lock
the side cover.
the power cords to electrical outlets.
Attention: For proper cooling and airflow, replace the cover before turning on
the computer. Operating the computer with the cover removed might damage
computer components.
94
13