ADTRAN NetVanta 950 IAD Quick Configuration Manual page 18

Hide thumbs Also See for NetVanta 950 IAD:

For this example we will map a single DS0 from a T1 WAN interface to an FXS port. The

NetVanta 950 IAD Octal FXS access module (1200791L1) must be installed for this application

to work. The following steps assume the Global Configuration mode is currently active. Verify

that the prompt of your unit displays (config)#.

1. Enter interface t1 0/1 to access the configuration parameters for the WAN 0/1 interface.

2. Enter tdm-group 1 timeslots 1 to create a TDM group for DS0 1 on the T1 network t1 0/1.

3. Enter exit to return to Global Configuration mode.

4. Enter cross-connect 1 t1 0/1 1.1 fxs 2/1 to connect DS0 1 of the T1 network to the FXS port

(fxs 2/1).

Create a T1 to FXO Cross-Connect

For this example we will map a single DS0 from a T1 WAN interface to an FXO port. The

NetVanta 950 IAD Octal FXO access module (1200792L1) must be installed for this

application to work. The following steps assume the Global Configuration mode is currently

active. Verify that the prompt of your unit displays (config)#.

1. Enter interface t1 0/1 to access the configuration parameters for the WAN 0/1 interface.

2. Enter tdm-group 1 timeslots 2 to create a TDM group for DS0 2 on the T1 network t1 0/1.

3. Enter exit to return to Global Configuration mode.

4. Enter cross-connect 2 t1 0/1 1.2 fxo 4/1 to connect DS0 2 of the T1 network to the FXO

port (4/1).

Technical Support 1-888-4ADTRAN (1-888-423-8726)

61200788L1-42A