Setting Up The Sequin Device; Installing The Sequin Device; Installing The Sequin Reel - KANSAI SPECIAL LX-SP Series Instructions Manual

【3】SETTING UP THE SEQUIN DEVICE

3-1 Installing the sequin device

■ I nstall the sequin device to the head cover with
screws A. (Fig.3)
■ T ighten the screws A after checking the followings.
1. The needle drops into the center of sequin hole.
(Fig.4)
2. The clearance range between the bottom surface
of sequin device and the top surface of the
needle plate should be 1.5~2.0mm.
And then, make sure it is paralleled. (Fig.5)

3-2 Installing the sequin reel

■ S et the sequin reel on the device as the following figure. (Fig.6)
(Fig.6)
■ I n case of setting the reverse rolled reel, the additional guide roller is needed as the above
figure. (Fig.7)
■ T ake away the original guide roller, and then assemble the assist plate and the additional
guide roller to the device with a nut "M4." Lastly, assemble the original guide roller to
the assist plate. (Fig.7)
(Fig.7)
(Fig.4)
(Fig.3)
(Fig.5)
2
-
-
Ｌ Ｘ Ｓ Ｐ s e r i e s
Ｌ Ｘ Ｓ Ｐ s e r i e s