Table of Contents
Advertisement
4-2 Adjusting the sequin hole position against the needle
Note: This adjustment is necessary only for:
If the needle drop position is incorrect into the sequin hole, after followed "4-1 Adjusting
the sequin cutting position."
■ A djusting the front-back position
1.
Loosen the screw A and B. (Fig.21)
2.
Adjust the needle drop position into the center
of the sequin hole, while pressing the feeding
bar by hand. (Fig.19,20)
3.
After adjusting the position, fasten the screw
A.(Fig.21)
4.
While keeping the feeding bar position by
pressing, tighten the screw B. (Fig.20)
(Fig.20)
■ A djusting the left-right position
1.
Loosen the screw C after opening the lock lever.
(Fig.21)
2.
Adjust the needle position to be dropped into
the center of sequin hole by turning round the
eccentric screw by a
※When the sequin hole is positioned at the left
side
against
tightening the screw D. (Fig.22)
3.
Tighten the screw C after adjusting the
position.(Fig.21)
4.
Tighten the nut F after the screw D touches
onto the side face at the correct needle drop
position into the center of the sequin hole.
(Fig.22)
※ Check back once more to "Adjusting front-back position", after finishing this
adjustment.
flathead
screwdriver.
the
needle,
adjust
(Fig.22)
it
after
7
(Fig.19)
(Fig.21)
-
-
Ｌ
Ｘ
Ｓ
Ｐ
s
e
r
i
e
s
Ｌ
Ｘ
Ｓ
Ｐ
s
e
r
i
e
s
Advertisement
Table of Contents
