Table of Contents
Advertisement
■ P attern setting (Fig.32)
While the operation stops, press "Set" to apply the changing after changing the sequin size.
The new setting is completely set right after pressing "Set."
※A "Set" bottom can be used to change both changing: size and pattern at the same time.
■ O ne shot switch (Fig.33)
Press "one shot" while the operation stops, then one sequin is fed from the sequin device.
This function is useful to check the setting accuracy when the sequin size or pattern is
changed.
Caution
Remember to adjust the sequin feed timing again, when the sequin size is changed.
In case of 3mm sequin as the following figure, the feeding amount must be needed at
least 1.5mm plus needle radius. (1.5mm is the sequin radius.)
(Fig.33)
14
(Fig.32)
(Fig.34)
-
-
Ｌ
Ｘ
Ｓ
Ｐ
s
e
r
Ｌ
Ｘ
Ｓ
Ｐ
s
e
r
i
e
s
i
e
s
Advertisement
Table of Contents
