Angle And Height For Installing The Loopers; Looper Setting Distance; Needle Height; Installing The Needle Holder - KANSAI SPECIAL SX Series Instructions Manual

6 6 6 6 - - - - 2 Angle and height for installing the loopers

2 Angle and height for installing the loopers 2 Angle and height for installing the loopers 2 Angle and height for installing the loopers
Insert loopers A, B and C fully into looper holders D, E
and F. Tighten screws G. Height and an angle of 3° ° ° °
are achieved.
6 6 6 6 - - - - 3 Looper setting di

3 Looper setting distance

3 Looper setting di 3 Looper setting di
With the loopers at the extreme left end of their travel,
there should be a distance of approximately 3.6mm from
each center of the needles to each point of the loopers.
Adjustment is made by loosening screws H.

6 6 6 6 - - - - 4 Needle height

4 Needle height 4 Needle height 4 Needle height
When each point of the loopers passing behind the needles
has reached each center of the needles, there should be a
distance of 1.5 ~ 2.0mm from each point of the loopers to
each top of the needles' eyes.
loosening screw J of the needle bar clamp and moving the
needle bar up or down as required.

6 6 6 6 - - - - 5 Installing the needle holder

5 Installing the needle holder 5 Installing the needle holder 5 Installing the needle holder
Torque the needle holder into the needle bar to 20kgf･cm.
stance
stance stance
Adjustment is made by
11