KANSAI SPECIAL LX-SP Series Instructions Manual page 9

■ I n case of wrong cutting position, adjust it with the following procedures.
1. Loosen the screw X on the sequin pressure foot
bracket. Refer to the right figure. (Fig.15)
2. Loosen the screw Z on the feeding bar to release
itself freely from the shaft. (Fig.16)
3. In case of wrong cutting position (a), loosen the nut
Y. Then, adjust the cutting position by turning up
the adjusting screw W, while pushing the feeding
bar to the direction "A" as the following figure.
(Fig.16)
4. In case of wrong cutting position (b), loosen the nut
Y. Then, adjust the cutting position by turning
down the adjusting screw W, while pulling the
sequin tape to the direction "B" as the following
figure. (Fig.16)
5. After adjustment, tighten the nut Y.
Lastly, tighten the screw Z on the feeding bar,
while pressing the feeding bar against the
adjusting screw W. (Fig.16)
Wrong cutting
Too Short
Too Long
6. When the top edge of the sequin presser foot is positioned on the center of the sequin
hole, and also, the top edge of the sequin feed nail is positioned on the center of the
another sequin hole, tighten the screw on the bracket of the sequin presser
foot.(Fig.17)
※ The position is different depending on the size of the sequin. (Fig.18)
7. Check the sequin cutting position after test cut.
Adjust it until showing the correct cutting position with repeating above procedures.
Adjusting Position of the
screw feeding nail
6
(Fig.17)
(Fig.18)
-
-
Ｌ Ｘ Ｓ Ｐ s
Ｌ Ｘ Ｓ Ｐ s
(Fig.15)
(Fig.16)
e r i e s
e r i e s