Advertisement
5
Installing the Wiper Motor
Assemblies
Parts needed for this procedure:
1
Counsel mount
8
Large clip nut
8
Washer
6
Bolt (1/4–2 x 1 inch)
1
Roof support
4
Small clip nut
1
Roof counsel
4
Bolt (#10)
Procedure
1.
Install the wiper motor
Figure 15
2.
Install 6 large clip nuts onto the counsel mount
as shown in
Figure
3.
Install the counsel mount onto the wiper mount
using 2 bolts (1/4–2 x 1 inch) and 2 washers
(Figure
16).
Figure 16
1. Bolts (1/4–2 x 1 inch)
2. Washers
4.
Install the roof mount using 2 bolts (1/4–2 x 1
inch)
(Figure
17).
(Figure
15).
16.
3. Large clip nuts
5.
Install 2 large clip nuts on the roof mount as
shown in
1. Bolt (1/4–2 x 1 inch)
2. Clip nuts, large
6.
Install the fuse and ground blocks
g253021
1. Ground block
7.
Install the roof trim seal into the top of the cab
frame
(Figure
Note:
Install the tall edge of the trim seal to the
outside edge.
8.
Use sealant to fill in any gaps
g253014
6
Figure
17.
Figure 17
3. Roof mount
Figure 18
2. Fuse block
19).
(Figure
g253018
(Figure
18).
g253016
19).
Advertisement
