Advertisement
Note:
Use soapy water to assist with installing
the bracket-support mounts.
Figure 44
1. Flange-head bolt (1/2 x
2-1/4 inches)
2. Rubber isolator
3. Spacer
11
Installing the Seat Shroud
No Parts Required
Procedure
Both machines:
1.
Align the opening in the seat shroud for the
parking brake with the parking-brake handle.
2.
Align the hole in the gear-selector boot with the
rod for the gear selector.
3.
Align the opening in the seat shroud for the rods
for the lift bed control, high-low range shifter,
and the differential lock.
4.
Lower the seat shroud down.
5.
Align the holes in the shroud for the seat
mounting with the seat-support brackets of the
chassis.
Do not tighten the bolts.
6.
Plug in the shift indicator and secure the controls
bracket with the screws
36) removed in
Removing the Seat Shroud
(page
10).
Important:
This step applies to Workman
HDX-Auto machines only.
g254261
4. Washer
5. Locknut
(Figure 34
and
Figure
12
Installing the Side-Plate
Panels and Cab Frame
Parts needed for this procedure:
2
Side-plate panel
1
Cab frame
4
Bolt (1/2 inch)
4
Washer (1/2 inch)
4
Nut (1/2 inch)
1
Lower dash seal
Procedure
1.
Loosen the bolts on the fenders approximately
1 turn to allow room for the side-plate panels to
slide into place.
2.
Slide the side-plate panels between the seat
shroud and side fenders
Note:
Ensure that the panels are seated fully
before tightening the bolts.
3.
Tighten the bolts on the fenders.
Note:
Do not overtighten the bolts.
4.
Install the lower dash seal to the cab
14
(Figure
45).
Figure 45
(Figure
g026246
46).
Advertisement
