Toro 137-1019 Installation Instructions Manual page 2

2
Removing and Preparing
the Cab
No Parts Required
Procedure
1. Hold the cab frame using the lifting points and
remove the hardware securing the cab to the
machine.
1. Lifting points
2. Lift the cab off of the machine.
3. Locate the left and right frame panels.
1. 3/4 inch
Figure 2
Figure 3
2. 3/4 inch
4. Cut a 3/4 inch notch on each side of the panel
as shown in
5. Remove the roof of the cab and remove the
parts of the wiper assembly
Note:
Save these parts to be installed again
later.
6. Add sealant to the seams of the cab
g026247
7. Add sealant to the seams of the wiper mount
(Figure 6
g253023
2
Figure 3).
(Figure
Figure 4
Figure 5
and Figure 7).
4).
g253075
(Figure 5).
g253027