Advertisement
6.
Add sealant to the installation location of the
wiper mount assembly (Box A of
7.
Install the foam seal onto the wiper mount frame
(Box B of
Figure
12).
Figure 12
1. Hex head bolts (5/16-18 x
3/4 inch)
2. Nut (5/16 inch)
3. Carriage bolt (5/16-18 x
3/4 inch)
8.
Install the wiper mount assembly onto the cab
frame (Box C of
Figure
Figure
12).
g253030
4. Bolt (1/4-20 x 1/2 inch)
5. Nut (1/4 inch)
12).
9.
Secure the wiper mount assembly using 3 hex
head bolts (5/16-18 x 3/4 inch), 2 carriage bolts
(5/16-18 x 3/4 inch), 2 nuts (5/16 inch), 2 bolts
(1/4-20 x 1/2 inch), and 2 nuts (1/4 inch) as
shown in Boxes D and E in
4
Routing the Wiper Motor
Wire Harness
No Parts Required
Procedure
Route the previously removed (step
and Preparing the Cab (page
13
and
Figure
14.
5
Figure
12.
5
of
2 Removing
1)) as shown in
Figure 13
Figure 14
Figure
g253026
g253011
Advertisement
