Toro 137-1019 Installation Instructions Manual page 20

Figure 60
1. Tube cut at a 45° angle and installed at the bottom edge of
the water gutter
16
Installing the Floor and
Side-Plate Panels
Parts needed for this procedure:
g246160
2 Floor-plate panel
2 Side-plate panel
1
Side-plate panel seal
12 Bolt (1/4 inch)
Procedure
1. Install the floor-plate panels on each side of
the machine using 3 bolts (1/4 inch) as shown
in Figure
1. Bolt (1/4 inch)
2. Torque the bolts to 1017 to 1243 N∙cm (90 to
110 in-lb).
3. Install the side-plate-panel seal onto the
side-plate panels
20
61.
Figure 61
2. Floor-plate panel
(Figure 62).
g026248