Toro 137-1019 Installation Instructions Manual page 11

1. Unplug the shift-indicator connector from the
machine harness
Figure 34
1. Shift-indicator connector
2. Lift and rotate the center control assembly out
of the way to gain access to the suspension
springs.
Both machines:
Lift the seat shroud up and remove it from the machine
(Figure 35).
Figure 35
For Workman HDX-Auto machines:
Remove the bolts securing the lift valve to the controls
bracket, and the nuts and bolts securing the control
bracket to the machine
(Figure 34).
2. Machine harness
(Figure 36).
1. Bolts securing the control
bracket to the machine
2. Bolts securing the lift valve
g025506
to the controls bracket
9
Installing the Inner Fender
Parts needed for this procedure:
1 Inner fender
2 Fender strap
6 Hex-head flange bolt (1/4 x 3/4 inch)
8 Flange nut (1/4 inch)
2 Rubber bumper
2 Washer
2 Cable tie
Procedure
1. Align the fender straps at the bottom edge of the
seat base frame, and use the fender straps as a
template to mark and drill 3 holes (5/16 inch) on
each side of the seat base frame
g026471
11
Figure 36
3. Bolts securing the control
bracket to the machine
4. Nuts
(Figure
g027095
37).