Advertisement
2.
Install the adjuster plate and back plate to the
dash-support tube using the 4 carriage bolts
(1/4 x 1-3/4 inches) and flange nuts (1/4 inch)
as shown in
Figure
Figure 52
1. Carriage bolt (1/4 x 1-3/4
inches)
2. Adjuster plate
3.
Install the tap bolt (1/2 x 4 inches), flange nut
(1/2 inch), and stop plate to the adjuster plate
(Figure
53).
Figure 53
1. Stop plate
2. Flange nut (1/2 inch)
52.
3. Flange nut (1/4 inch)
4. Back plate
3. Adjuster plate
4. Tap bolt (1/2 x 4 inches)
4.
Close the gap between the dash and cab by
adjusting the tap bolt (1/2 x 4 inches) until the
stop plate pushes upward on the dash
54).
g245999
1. Gap between the dash and cab
g246000
17
Figure 54
(Figure
g246149
Advertisement
